Before you begin any of the procedures in this section, follow the safety instructions in your Owner’s Manual. Ensure that the floppy drive or the hard drive is installed correctly in the computer and defined correctly in the system setup program. Enter the system setup program , verify the system configuration, and then restart the computer. Continue until you have identified a faulty module or reinstalled all modules without error. Ensure that the cables are properly connected from the hard drive, CD drive, and DVD drive to the system board. Timer-chip counter 2 failure. The system configuration information in the system setup program is incorrect or the battery charge may be low.

Uploader: Akidal
Date Added: 12 December 2017
File Size: 52.56 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 4312
Price: Free* [*Free Regsitration Required]

The system configuration information in the system setup program is incorrect or the battery charge may be low. If you hear one of the following beep codes, see “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance.

If the computer malfunctions, the color and sequence of the lights identify the problem. Ensure that the cables are properly connected from the hard drive, CD drive, and DVD drive to the system board. Continue until you have identified a faulty module or reinstalled all modules without error.

  CREATIVE MODEL CT4750 DRIVER

Check the interface cable at both ends. Before you begin any of the procedures in this section, follow the safety instructions in your Owner’s Manual.

An error is occurring on the timer on the system board. The computer is in a normal off condition or a possible pre-BIOS failure has occurred.

Strike F1 to retry reboot, F2 for setup utility. The operating system cannot be located on drive A or drive C. This series of beeps, called a beep code, identifies a problem.

Dell Dimension

If you receive this message after you make changes in the system setup program, videl the system setup program and restore the original value s. Reinstall all memory modules and restart the computer. Slave DMA 46000c failure. Reinstall all USB devices, check cable connections, and then restart the computer. Reseat all power and data cables and restart the computer. Master interrupt mask register failure. Determine if a conflict exists by removing a card and then restarting the computer.

Dell Dimension – Wikipedia

To help you troubleshoot a problem, your computer is equipped with four lights on the back panel labeled “A,” “B,” “C,” and “D. Video Memory Test failure. Continue until you have identified vvideo faulty connector or reinstalled all modules without error. A possible floppy or hard drive failure has occurred. A possible expansion card failure has occurred.

  MEMOREX 6136 SCANNER DRIVER

If the problem persists, see “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance. If the problem persists, reinstall the cards that you removed, remove a different card, and then restart the computer.

If the computer starts normally, move the memory module to vide different connector and restart the computer. Serial or parallel port test failure. Verify that the computer is plugged into a working electrical outlet and that you have pressed the power button.

This beep code tells you that the computer encountered a memory problem. The hard drive is not working or is not configured correctly. To eliminate the possibility of a faulty memory connector, remove all memory modulesreinstall one memory module if the computer supports a single moduleand then restart the computer.

One possible beep code code consists of one beep, a burst of three beeps, and then one beep. Enter the system setup program and confirm that drive A or drive C is properly identified.

Verify that the memory modules that you are installing are compatible with your computer.