Mike, I am taking the advantage of asking you for help. You need to make sure that you have up to date software to support your target. This discussion assumes a single DSP target and no other devices in the scan chain. You can also search ti. The red usb active light will light for about one second and then turn off.
|Date Added:||26 January 2008|
|File Size:||63.16 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The BDI appears to work with the omap35xx. Then, finally, i had a blackhawk emulator displayed in device manager.
The error message portion “Target CPU: The important initial minimum steps to get past this problem are as follows: They also have a BeagleBoard Adapter Kit. Blackhawk is a business unit of ewaewa technologies, inc. The code that you are running could be written for a different C family member than you are using causing the invalid address.
Xds emulation software package texas instruments wiki. Spectrum digital xds usb plus usb jtag emulator although we welcome your questions and inquiries by email or phone, buyers are expected to do their own research in regard to the compatibility andor software driver requirements for any item they are considering purchasing. There is no need to install a new blackhawk driver with ccs v4. Introduction Today I am going to discuss blackkhawk of the basics that can help prevent errors that frustrate some users.
If you are currently using the technology and have no issues, there is no need to change but no support is provided. Connect the xds xdsv2 usb lbackhawk emulator to your pc through a usb cable and apply power to xdsv2. Sau xdsusb lite jtag emulator has ultraminiature design smallest xds class emulator of currently produced. Check the section Part Numbers below.
To post a new comment not a reply to a comment check out the ‘Write a Comment’ tab at the top of the comments.
Resolving ‘Can’t initialize target CPU’ on TI C DSPs – Part 1 – Mike Dunn
Next time when i plugged in the emulator to the usb port, i pointed windows to install the driver from d. The emulator adaptor is titled a blockmode adapter for blackhawk usb emulators.
Designed to deliver good performance and the most common features that place it between the low cost xds and the high performance xdsv2, the xds is the balanced solution to debug ti microcontrollers, processors and wireless devices.
You need to make sure that you have up to date software to support your target. Xds usb jtag emulator spectrum digital inc. Mike has over 30 years of direct involement with embedded systems like communication controllers, mainframe and minicomputer peripheral controllers, custom minicomputers, microcontrollers and DSPs.
Please post only comments about the article XDS here. This page has been accessed 22, times. But wait – that may not be enough. With the fastest speeds and most features of the entire xds family, xdsv2 is the most comprehensive solution to debug ti microcontrollers, processors and wireless connectivity microcontrollers. Tmdsemuv2stmu xdsv2 system trace usb debug probe.
Blackhawk xds510 usb driver
I hope this helps. If you have a non-TI emulator that did not provide a turnkey configuration for your target, you can use the following tip to get the setup correct.
Performance of the xds is lower than the xds and xds